Pilz PSSnet SHL 8T MRP - Manual (Page 26)

Quick Start up
26
2.2 System Info and System Setup
PSSnet SHL - Command Line Interface
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
U Quick Start up Physical Port Data
U Quick Start up User Account Management
Command Details
show port all
(in Privileged EXEC)
Displays the Ports
slot/port
Type - Indicates if the port is a special type of port
Admin Mode - Selects the Port Control Administration State
Physical Mode - Selects the desired port speed and duplex mode
Physical Status - Indicates the port speed and duplex mode
Link Status - Indicates whether the link is up or down
Link Trap - Determines whether or not to send a trap when link status
changes
LACP Mode - Displays whether LACP is enabled or disabled on this
port.
Table 9: Quick Start up Physical Port Data
Command Details
show users
(in Privileged EXEC)
Displays all of the users that are allowed to access the
switch
Access Mode - Shows whether the user is able to change
parameters on the switch(Read/Write) or is only able to
view them (Read Only).
As a factory default, the ‘admin’ user has Read/Write
access and the ‘user’ user has Read Only access. There
can only be one Read/Write user and up to five Read Only
users.
show loginsession
(in User EXEC)
Displays all of the login session information
Table 10: Quick Start up User Account Management