Pilz PSSnet SHL 8T MRP - Manual (Page 221)

PSSnet SHL - Command Line Interface
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
4.9 LLDP - Link Layer Discovery Protocol
221
4.9.12 show lldp remote-data
This command shows all LLDP remote-data settings and states concerning
one or all ports.
Format
show lldp remote-data <{slot/port|all}>
Mode
Privileged EXEC and User EXEC
chassis-id
Display the remote data's chassis ID only.
detailed
Display remote data in detailed format (i. e., all available data).
Note: most important data is output first (not in alphabetic order of
command names). This is the default command if no specific
command is given.
ether-port-info
Display the remote data's port Ethernet properties only (group com-
mand, outputs: Port Autoneg. Supported, Port Autoneg. Enabled,
Port Autoneg. Advertized Capabilities and Port Operational MAU
Type).
inlinepower
Displays the remote port's Power over Ethernet capabilities (PoE,
IEEE 802.3af). Included are if the remote device is a PSE (Power
Source Device) or a PD (Powered Device), if PoE is supported and if
the power pairs are selectable.
link-aggregation-info
Display the remote data's link aggregation information only (group
command, outputs: Link Agg. Status and Link Agg. Port ID).
mgmt-addr
Display the remote data's management address only.
port-desc
Display the remote data's port description only.
port-id
Display the remote data's port ID only.