Altera Arria 10 Avalon-ST - Manual (Page 107)

Parity Signals
You enable parity checking by selecting Enable byte parity ports on the Avalon-ST interface under the
System Settings heading of the parameter editor. Parity is odd. This option is not available for the
Avalon-MM Arria 10 Hard IP for PCI Express. Parity protection provides some data protection in
systems that do not use ECRC checking.
On the RX datapath, parity is computed on the incoming TLP prior to the LCRC check in the Data Link
Layer. Up to 32 parity bits are propagated to the Application Layer along with the RX Avalon-ST data.
The RX datapath also propagates up to 32 parity bits to the Transaction Layer for Configuration TLPs. On
the TX datapath, parity generated in the Application Layer is checked in Transaction Layer and the Data
Link Layer.
The following table lists the signals that indicate parity errors. When an error is detected, parity error
signals are asserted for one cycle.
Table 6-12: Parity Signals
Signal Name Direction Description
tx_par_err[1:0] Output When asserted for a single cycle, indicates a parity error during
TX TLP transmission. These errors are logged in the VSEC
register. The following encodings are defined:
• 2’b10: A parity error was detected by the TX Transaction
Layer. The TLP is nullified and logged as an uncorrectable
internal error in the VSEC registers. For more information,
refer to Uncorrectable Internal Error Status Register.
• 2’b01: Some time later, the parity error is detected by the TX
Data Link Layer which drives 2’b01 to indicate the error.
Altera recommends resetting the Arria 10 Hard IP for PCI
Express when this error is detected. Contact Altera if resetting
becomes unworkable.
Note that not all simulation models assert the Transaction Layer
error bit in conjunction with the Data Link Layer error bit.
rx_par_err Output When asserted for a single cycle, indicates that a parity error was
detected in a TLP at the input of the RX buffer. This error is
logged as an uncorrectable internal error in the VSEC registers.
For more information, refer to Uncorrectable Internal Error
Status Register. If this error occurs, you must reset the Hard IP if
this error occurs because parity errors can leave the Hard IP in an
unknown state.
UG-01145_avst
2015.05.04
Parity Signals 6-41
Interfaces and Signal Descriptions Altera Corporation
Send Feedback