Adept s650HS Quattro - Manual (Page 150)

Chapter 8: Maintenance - H
Figure 8-11. Spring, with End Removed from Horseshoe
The narrowest part of the horseshoe is 90° from the groove in which the spring
end normally rests.
3. Repeat these steps for the remaining spring.
Removing Outer Arm Spring Horseshoes
NOTE: The only reason for removing an outer arm horseshoe is to replace one that
has been damaged.
1. Remove the outer arm springs from the horseshoe. See the previous section.
2. Cut the horseshoe with diagonal cutters.
Take care not to damage any part of the outer arm end.
3. Remove the cut horseshoe from the outer arm pins.
Installing Outer Arm Spring Assemblies
Installing Horseshoes
1. Slip one end of the horseshoe over one of the outer arm pins. See the following figure.
Adept Quattro User's Guide, Rev F
Page 150 of 196