Adept s650HS Quattro - Manual (Page 38)

Chapter 2: Robot Installation - H
In addition, +X and +Y World Coordinates are labeled on the platform near the flange.
See Figure 2-6.
l
Electroless nickel platforms are not labeled. Refer to Figure 2-7.
l When installing the platform, the numbers on the platform must match the numbers on
the underside of the robot base.
Figure 2-6. Platform Orientation Labeling (P34 shown)
NOTE: The labeling on all anodized platforms is the same except for the part
number.
Adept Quattro User's Guide, Rev F
Page 38 of 196