Adept s650HS Quattro - Manual (Page 178)

Chapter 9: Maintenance - HS
Removing Outer Arm Spring Horseshoes
NOTE: The only reason for removing an outer arm horseshoe is to replace one that
has been damaged.
1. Remove the outer arm springs from the horseshoe. See the previous section, See
"Removing Outer Arm Springs".
2. Cut the horseshoe with diagonal cutters.
Take care not to damage any part of the outer arm end.
3. Remove the cut horseshoe from the outer arm pins.
Installing Outer Arm Spring Assemblies
Installing Horseshoes
1. Slip one end of the horseshoe over one of the outer arm pins. See the following figure.
Figure 9-12. Horseshoe over One Pin
2. Pull the loose end of the horseshoe (spreading it slightly), and slip the end on top of the
other outer arm pin.
The horseshoes are very stiff, and do not bend easily. See the following figure.
Adept Quattro User's Guide, Rev F
Page 178 of 196