Adept s650HS Quattro - Manual (Page 49)

Chapter 3: Robot Installation - HS
Components
l Cable Inlet box
l Cable Inlet box cover
l Cable Inlet box-cover gasket
l
Cable Inlet box-AIB/eAIB gasket
l Compression Block kit - Roxtec CF 8-8
l
Roxtec CF 8 frame
l 4 x 2-hole Roxtec modules
These are dense foam blocks surrounding pre-cut half-sleeves that can be peeled
away to match the diameter of the cable to be sealed. The installation procedure
follows.
l Roxtec grease, used to assemble and seal the modules.
NOTE: The Roxtec CF 8 consists of a frame and integrated compression unit (a
wedge and bolt that compress the modules once they are assembled inside the CF
frame). See Figure 3-10.
l 4 x Screws, M4 x 40 (cable box-AIB/eAIB; one is used for the ground)
l 1 x Washer, ETL, SS M4 (for ground screw)
l
4 x Screws, M4 x 16 mm (for the back cover)
l
4 x Washer seals (for the back cover screws)
l 4 x Screws, M4 x 12 mm (for attaching the cable tray)
The following may be included as spares:
l 4 x Screws, M4 x 16 mm (for the cable tray)
l 4 x Washer seals (for the cable tray screws)
l
4 x Washers, ETL, SS M4 (for the cable tray)
Tasks
1. Measure and mark cables to establish service length
2. Adapt Roxtec modules to fit cables
3. Install cables through cable inlet box (via Roxtec modules)
4. Attach cables to AIB/eAIB
5. Install AIB/eAIB cable inlet box
6. Attach cable inlet box back cover
Adept Quattro User's Guide, Rev F
Page 49 of 196