Auto-Zone Control Systems Auto-Zone Basic Systems Installation & Operation (Version 02C) - Manual (Page 102)

Section 4
Start-Up & Troubleshooting
Table of Figures & Tables
Figure 4-1: Basic System Communications Wiring ......................................................2
Figure 4-2: Zone Manager Communications Wiring & Address Switch Setting .........3
Figure 4-3: Zone Controller Communications Wiring & Address Switch Setting.......4
Figure 4-4: CommLink IV (Optional) Wiring...............................................................5
Figure 4-5: CommLink IV (Optional) Jumper Settings ................................................6
Figure 4-6: Zone Manager Components .......................................................................8
Figure 4-7: Zone Manager Wiring.................................................................................9
Figure 4-8: Zone Controller Components ...................................................................10
Figure 4-9: Zone Controller Wiring ............................................................................11
Figure 4-10: Basic Zone Manager ..............................................................................16
Table 4-1: SCAN LED Blink Codes............................................................................18
Figure 4-11: Bypass Damper Troubleshooting...........................................................38
Table 4-2: Temperature Sensor Resistance .................................................................39
Table 4-3: Pressure Sensor Voltage ...........................................................................40
Figure 4-12: Driver Chip Locations............................................................................41
Figure 4-13: Replacing Driver Chips..........................................................................42