Auto-Zone Control Systems Auto-Zone Basic Systems Installation & Operation (Version 02C) - Manual (Page 91)

Auto-Zone Basic Section 3
Programming 3-23
Configuration Screen #8
Caution: If you forget your passcode, you WILL BE locked out of your system!
Tip: The BackDoor Passcode that will always get you into the system is "9288." This
passcode should not be given to the casual users of your system.
As mentioned earlier, the default passcode is "1111". This
code must be entered before any configuration or setpoint
changes can occur. If you would like to change this default
passcode, enter four digits on this screen. The value entered
must be between 1000 and 9999 to be a valid code. Values
from 0000 to 0999 will be rejected and the last valid code will
be retained.
Enter New Passcode
CODE: xxxx
[Must Be 4 Digits]
Press <A> To Skip!