Auto-Zone Control Systems Auto-Zone Basic Systems Installation & Operation (Version 02C) - Manual (Page 95)

Auto-Zone Basic Section 3
Programming 3-27
Index
"K" Flow Factor .................................. 12
# - Enter Button..................................... 2
# - Menu Button .................................... 1
# Key................................................. 2, 9
* - Decimal Button................................ 2
1111....................................................... 9
24-Hour Format .................................. 14
A - Abort Button ................................... 2
A - Summary Button ............................. 1
A Key .................................................... 2
Active Cooling Stages .......................... 6
Active Heating Stages........................... 6
Address Range .................................... 20
Airflow (CFM) Setpoint ..................... 11
Airflow (CFM) Values........................ 12
Alarm
Definitions ........................................ 8
Status Screens ................................... 7
Alarm LED............................................ 7
Auto Mode .......................................... 24
Aux Heating On .................................... 4
AuxHeat Setpt..................................... 11
Auxiliary Alarm ................................ 7, 8
Auxiliary Heat Off ................................ 4
Auxiliary Heating Relay ..................... 11
B - Backup Button ................................ 2
B - Status Button................................... 1
B Key .................................................... 3
Back Door Passcode ........................... 23
Bad Supply Air Sensor ..................... 7, 8
Bad Zone Sensor ............................... 7, 8
Box & Aux Heat On ............................. 4
Box Heating On .................................... 4
Buttons
# - Enter ............................................ 2
# - Menu............................................ 1
* - Decimal........................................ 2
A - Abort ........................................... 2
A - Summary..................................... 1
B - Backup ........................................ 2
B - Status........................................... 1
C - Clear............................................ 2
C - Status........................................... 1
D - Alarms......................................... 1
D - Negative...................................... 2
Bypass Damper
Direct Acting................................... 22
Reverse Acting................................ 22
Bypass Damper Position ....................... 5
Bypass Feedback Fail ........................... 8
C - Clear Button .................................... 2
C - Status Button................................... 1
C Key .................................................... 5
Calibrating ............................................ 3
Calibration Offset ............................... 13
CFM @1”WG xxxxx CFM................. 12
Changeover Delay Time ..................... 18
Closed Volts........................................ 18
Configuration
Internal Week Schedule .................. 22
Real-Time Clock............................. 22
Configure System.................................. 9
Control Setpoints .......................... 14, 17
Zone Manager ................................. 14
Cool Lockout ...................................... 17
Cool Mode Min................................... 11
Cool SetUp.......................................... 11
Cool Staging ....................................... 18
Cooling.................................................. 4
Cooling Failure ..................................... 8
COOLING FAILURE........................... 7
Cooling Setback .................................. 11
Cooling Setpoint ................................. 10
Cooling Setpt ...................................... 10
Cooling Stages .................................... 20
Cooling Total ........................................ 6
CSP ....................................................... 3
Current Cooling Setpoint ...................... 3
Current Zone Temperature ................... 3
D - Alarms Button................................. 1
D – Negative Button ............................ 2
D Key .................................................... 7
Damper Closing Alarm ..................... 7, 8
Damper Feedback Fail .......................... 7