Auto-Zone Control Systems Auto-Zone Basic Systems Installation & Operation (Version 02C) - Manual (Page 118)

Section 4 Auto-Zone Basic
4-16 Start-Up and Troubleshooting
Start-Up
On Auto-Zone Basic Control System power up, the following tests, calibration, initializa-
tion, and procedures occur:
Figure 4-10: Auto-Zone Basic Zone Manager
Initializing
System
Please Wait
Start-Up Delay 49
Number of Zones 1
03/27/02 09:20am Wed
STATIC NULL: 0.25
Start-Up Delay 49
Number of Zones 1
03/27/02 09:20am Wed
STATIC NULL: 0.25
Start-Up Delay 49
Number of Zones 1
03/27/02 09:20am Wed
STATIC NULL: 0.25
Start-Up Delay 49
Number of Zones 1
03/27/02 09:20am Wed
STATIC NULL: 0.25
POWERUP TEST
FA N
CO OL
1
CO OL 2
HE AT 1
HE AT 2
BYP
AS S O PEN
BY PA SS CL OS E
CO MM UNIC
AT ION
ALA
RM
A =
ALL
ZO NE S
B = EA CH ZO NE
C = HV AC UN IT/C LE AR
D =
AL AR MS
# = STE
P/E NT ER
* = D ECIM
AL
+
+
+
+
Cool
Mode
04-22-02
03:48PM
MON
OCCUPIED
NO
ALARMS
2
8
5
0
A
C
B
D
1
7
4
*
3
9
6
#
Keypad
Display
1.) The system setpoints are loaded and outputs are
turned off and the LEDs are initialized ON. The
screen displays, “Intialializing System.”
2.) System Diagnostics and Calibrations occur.
a.) A 50-second startup delay occurs. While this
is counting down, the LEDs will extinguish,
one every 6 seconds.
b.) The number of zones displays on the second
line. If the Zone Manager has never been
configured, the system will only show "1"
zone. If this isn't the first power-up, it will
display the number of zones for which the
system is configured.
c.) The current date and time displays on the
third line. If this is the first power-up, the
date and time may be incorrect.
d.) The Static Pressure Sensor NULL Voltage
displays on the bottom line. The static pres-
sure sensor NULL voltage is read at the fac-
tory during power-up checks prior to ship-
ping. If necessary, you can re-calibrate the
pressure sensor using the procedure de-
scribed in Section 3, Zone Manager Configu-
ration, Configuration Screen #7.