Auto-Zone Control Systems Auto-Zone Basic Systems Installation & Operation (Version 02C) - Manual (Page 31)

Auto-Zone Basic Section 2
Installation and Wiring 2-1
Tips Before Beginning
Installation
Take a few moments to review the following before beginning installation of the
Auto-Zone
Basic Control System.
• Familiarize yourself with all system components and review all documentation.
Pay special attention to “Cautions” and “Warnings” since these may keep you
from experiencing unnecessary problems.
Before installing zone dampers, be sure to tag each damper with its appropriate location.
It is also best to set the zone controller address switches before mounting in drop ceilings.
Use the Basic System Worksheet found in the back of this section or in the Basic Submit-
tal Package to list all zone locations and Zone Manager configurations. This will assist
you greatly when setting up the system.
• Be sure to install all wiring according to local, state, and national codes.
• Pay close attention to communication wiring since the most common mistakes are
made in this area. Polarity is the most important rule. Make notes on your wiring dia-
grams as to which color wire you will be using on each terminal.
• When in doubt - ask! Contact your local Auto-Zone distributor if you have any ques-
tions. The only dumb questions are the ones you don’t ask.
• Remember - each electronic device contains only one puff of smoke. If you release it,
you have voided the warranty! So please be careful and pay attention.