Comtech EF Data NetVue Release 1.1 User Guide - Manual (Page 65)

Operations Revision 3
NetVue User Guide MN-NETVUE
2–32
2.3.3.2.3 Rename a tab
Alarm tabs named new tab cannot be renamed, unless you apply an Alarm filter. You can specify a new
Alarm tab name after a filter is applied.
• Right-click the name of an Alarm tab.
• Click Change Tab Name.
2.3.3.3 List columns
NOTE: See the Note in Section 2.3.3.2.
2.3.3.3.1 Sort a list by a specific column
You can sort a list according to the contents of a selected column. A small Up or Down arrow to the right
of the column header shows the sorting order.
• Click a column header to sort the list.
• Click the column header again to reverse the sort order.
2.3.3.3.2 Show or hide a column
• Right-click any column header in the list to open the Add/Remove Column submenu.
• Find the name of the column to show or hide, and check or clear the check box next to it.
2.3.3.3.3 Change the position of a column
Drag the column header to a different position.
2.3.3.3.4 Reset the column layout to the factory default
• Right-click any column header in the list to open the Add/Remove Column submenu.
• Click Set Default Columns.
2.3.3.4 Filter Alarms and Information Events
Use these Filter options to refine and focus the Alarms or Information Events that are listed on a tab.