Verilink 8100A (34-00237) Product Manual - Manual (Page 102)

4-28 8 0 0 0 S e r i e s
Figure 4.43 PPP Authorization Menu
4 The IAD displays the current PPP authorization and prompts you to change
it. If you select options 1 through 4, the IAD displays the current PPP
authorization user ID and prompts you to enter a new PPP user ID.
5 Enter the new user ID and press Enter and then type a password and press
Enter. If you select option 0 (None), the IAD displays the IPCP IP Address
Type menu.
Figure 4.44 IPCP Configuration Menu
6 Type the option corresponding to the IP address you want to use. The IAD
displays the status of the DNS server assignment for the selected port, and
prompts you to enable or disable it:
7 Type “E” to enable, or “D” to disable the RFC 1877 DNS server
assignment for this port. The IAD reports the change, displays the status of
the DNS server assignment for the port, and prompts you to enable or
disable it.
8 Type “E” to enable, or “D” to disable the CISCO proprietary IP mask
assignment for this port. The IAD then displays the ATM Service Category
Configuration menu (Figure 4.38).
The IAD prompts for Service Category and PCR as shown in Figure 4.38, and
then displays the menu shown in Figure 4.39. For Service Category VBRt or
VBRnrt, the IAD prompts for Sustained Cell Rate (SCR) and Maximum Burst
Size (MBS).
NOTICE: VBRrt is mapped to CBR and VBRnrt is mapped to UBR.; therefore,
only the PCR values are used.