Verilink 8100A (34-00237) Product Manual - Manual (Page 125)

C o n f i g u r a t i o n 4-51
Clear IP filtering
statistics
Clears all accumulated statistics.
Configure IP Header Compression (IPHC)
IPHC reduces the number of bytes transmitted across the WAN, thus
conserving bandwidth.
To enable or disable IP header compression, follow the steps below:
1 On the Router Configuration menu (Figure 4.59), type “Q”.
2 The IAD displays the port table and prompts you to enter a port.
3 Type the port number and press Enter. The IAD displays the header
compression status and prompts you to enable or disable IP Header
Compression for SDSL.
4 Type “E” to enable IP header compression on this port, or “D” to disable it.
If you enable IP header compression, the IAD displays a message similar to
the following:
Springtide Compatibility mode ENABLED (currently not
selectable)
The IAD saves the changes and displays the Router Configuration menu
(Figure 4.59). Continue with other configuration tasks, or press Escape to
return to the Main menu.
Configure LAN IP Broadcast Destination
To set the LAN IP broadcast destination address (where all broadcast IP
packets received on the LAN ports will be redirected), follow the steps below.
1 On the Router Configuration menu (Figure 4.59), type “B”.
2 The IAD displays the current LAN IP broadcast destination address and
prompts you to enter a new address.
3 Type the new IP address. The IAD saves the changes and displays the
Router Configuration menu (Figure 4.59).
4 Continue with other configuration tasks, or press Escape to return to the
Main menu.
Configure Domain Name
To configure the Domain Name, follow the steps below.
1 On the Router Configuration menu (Figure 4.59), type “G”.
2 The IAD displays the current Domain Name and prompts you to enter a new
one.
3 Continue with other configuration tasks, or press Escape to return to the
Main menu.