Verilink 8100A (34-00237) Product Manual - Manual (Page 182)

4-108 8 0 0 0 S e r i e s
Display NAT Local Server Table
When NAT is enabled, you can display the entries in the local server table.
1 To display the table, type “O” on the NAT Configuration menu.
2 Press any key to return to the NAT Configuration menu.
Display NAT Alias Table
When NAT is enabled, you can display the entries in the NAT alias table. To
display the table, type “E” on the NAT Configuration menu. Press any key to
return to the NAT Configuration menu.
Clear NAT Statistics
When NAT is enabled, type “K” on the NAT Configuration menu to clear all
NAT statistics.
Type TCP or UDP
Seconds since use Idle time in seconds for the connection
TCP/UDP Sequence TCP sequence number
Ack TCP ack number
State TCP state number (TCP only)
Retrys: local, foreign: local—TCP retransmissions from local device to foreign
device.
foreign—TCP retransmissions from foreign device to
local device.
Bad checksum: local,
foreign local—packets with bad TCP checksums from local
device.
foreign—packets with bad TCP checksums from foreign
device.
Report Entry Description
Entry Table entry number
Local IP Address IP address in use
Local Port local port number
Internet Port Internet port number
Protocol The protocol used—TCP or UDP
Report Entry Description
Entry number Table entry number (1 to 7)
Local IP Address Local, or LAN IP address
Internet IP Address Internet IP address assigned
Report Entry Description