Verilink 8100A (34-00237) Product Manual - Manual (Page 111)

C o n f i g u r a t i o n 4-37
Figure 4.56 Frame Relay Management Protocol Menu
2 Type the number that corresponds to the protocol on your network and press
Enter.
Configure Congestion Parameters
To configure Congestion Parameters, follow the steps below.
1 Type “3” on the Frame Relay Options menu to display the Fame Relay
Congestion Configuration menu (Figure 4.57).
Figure 4.57 Frame Relay Congestion Configuration Menu
2 Select Configure Transmit Congestion Parameters and then follow the on-
screen messages to
•
FECN/BECN condition set size
•
FECN/BECN condition clear size
•
FECN/BECN max number of bytes to store
− or −
Select Configure Receive Congestion Parameters and then follow the on-
screen messages to
• FECN/BECN condition set size
• FECN/BECN condition clear size
• FECN/BECN max number of bytes to store
4 Reset the IAD for changes to take effect.