Verilink 8100A (34-00237) Product Manual - Manual (Page 110)

4-36 8 0 0 0 S e r i e s
1 Type “3” on the Frame Relay FRF.12 Configuration menu to manually set
fragment sizing. The IAD prompts you to enter the maximum fragment size.
2 Type the maximum fragment size in milliseconds or bytes and press Enter.
The IAD saves the configuration and displays the FR FRF.12 Configuration
menu. Press Escape to continue.
Configure
CopperMountain
Fragmentation
Configuration
Select Configure CopperMountain Fragmentation by typing “2” on the FR
Fragmentation Configuration menu to display the CopperMountain FR
FRF.12 Configuration menu (Figure 4.55).
NOTICE: With CMCP enabled, the DSLAM controls fragmentation settings, and
IAD configuration is not required.
Figure 4.55 Copper Mountain FRF.12 Configuration Menu Proprietary for
CopperMountain DSLAMs
Each option on this menu is described in detail below.
Enable/Disable Copper Mountain Fragmentation
1 Type “1” to display a prompt that lets you enable or disable
CopperMountain fragmentation.
2 Type “E” to enable CopperMountain fragmentation or type “D” to disable.
The IAD saves the configuration and displays the FR FRF.12 Configuration
menu. Press Escape to continue.
Set Real-Time DLCI
1 Type “2” to set up the IAD for real-time DLCI. The IAD displays the port
table and prompts you to select a port.
2 Type the port number corresponding to the DLCI you want to set to real-
time. The IAD saves the configuration and displays the FR FRF.12
Configuration menu. Press Escape to continue.
Configure Management Protocol
To configure Management Protocol, follow the steps below.
1 Type “2” on the Frame Relay Options menu to display the Configure
Management Protocol menu (Figure 4.56).