Verilink 8100A (34-00237) Product Manual - Manual (Page 228)

6-8 8 0 0 0 S e r i e s
set lan rip (off|(on(1|2Bcst|2Mlti))) [<slot>
[<interface> [<port>]]]
off | on
Keyword to disable (off) or enable (on) RIP on the specified port.
1 | 2Bcst | 2Mlti
Keyword identifying version to implement.
set lan stp
bridge
Enables or disables Spanning Tree Protocol on a LAN port.
set lan stp bridge (off|on) [<slot> [<interface>
[<port>]]]
off | on
Keyword to disable (off) or enable (on) STP on the specified port.
set loopback Sets up a loopback test on T1 Network Port only.
set loopback (line|payload|local|clear|(far
line)|(far payload)) [<slot>]
line | payload | local | clear | far line | far payload
Determines which loopback is used. Clear is used to remove the loop.
set mgcp
bracketing
When communicating with the notified entity (call agent), indicates whether
the UDP port number should be wrapped in brackets for compatibility.
set mgcp bracketing (off|on)
off | on
Keyword to disable (off) or enable (on) MGCP bracketing.
set mgcp fqdn Sets the fully qualified domain name.
set mgcp fqdn (off|on)
off | on
Keyword to disable (off) or enable (on) FQDN.
set mgcp lcs Sets the line control service.
set mgcp lcs (off|on)
off | on
Keyword to disable (off) or enable (on) MGCP LCS.
set mgcp
listening port
Specifies the UDP port the Notified Entity (call agent) is listening on.
set mgcp listening port <port>
port
UDP Port number (any valid port number; usually 2427 or 2727)
set mgcp nat Determines if and how often MGCP will send keep-alive packets to keep a
translation through a NAT device active.