Verilink 8100A (34-00237) Product Manual - Manual (Page 244)

7-6 8 0 0 0 S e r i e s
IAD is improperly
provisioned at the
voice gateway
Incorrect network
provisioning
Incorrect directory
number at the Class 5
switch
Verify and correct
provisioning of IAD as
required (refer to page 5-2).
Check and correct network
provisioning at DSLAM,
network switches, etc.
Check and correct as required
Cannot receive or send data Incorrect PVC/DLCI
set for data channel Verify these settings:
VPI: 0 to 255
VCI: 0 to 65535
DLCI: 16 to 1023
(default PVC 0/38; DLCI 32)
View Interface (page 5-13)
and Media statistics
(page 5-22) to check the pack
receive and send status.
Incorrect network
setup Check and correct network
setup as necessary.
If IAD is configured as a router:
Incorrect or missing
LAN or WAN IP
address Ensure that both the LAN and
WAN IP addresses are
configured.
Incorrect or missing
default static route Review the routing table and
correct as necessary
(page 5-31).
Incompatible RIPv1 Check and correct subnet
masks (255.255.255.0)
Update RIPv1 to RIPv2.
If IAD is configured as a bridge:
Incorrect bridging
parameters Review IAD configuration
(page 5-2) and current bridge
status (page 5-32).
Correct as necessary
Incorrect connection Ensure the IAD is connected
to another bridge
Missing peer or
converter Install a converter to convert
1483 cells to Ethernet packets.
Symptom Probable Cause Corrective Action