Verilink 8100A (34-00237) Product Manual - Manual (Page 224)

6-4 8 0 0 0 S e r i e s
reset system
set bridge global Enable or disables bridging globally.
set bridge global (off|on)
off | on
Keyword to disable (off) or enable (on) bridging globally.
set bridge stp
global
Enables or disables Spanning Tree Protocol globally.
set bridge stp global (off|on)
off | on
Keyword to disable (off) or enable (on) STP globally.
set buildout Determines the buildout level for the T1 network port only.
set buildout (133|266|399|533|655|0|-7.5|-15|-22.5)
[<slot>]
133 | 266 | 399 | 533 | 655
These values are for a DSX-1 short haul and values are in feet.
0 | -7.5 | -15 | -22.5
These values are for a WAN long haul and values are in decibels.
set channels Sets which channels on the T1 network port are enabled or disabled.
set channels (off|on) <low-chan> <high-chan> [<slot>]
off | on
Keyword to disable (off) or enable (on) the DS0 channels for the network
port.
low-chan
Lowest channel number you are changing.
high-chan
Highest channel number that you are changing.
set clocking Sets clock source for the T1 network port.
set clocking (internal|external) [<slot>]
internal | external
Allows T1 network port timing to be internal or received from network.
set dhcp client
enable
Determines if the specified port will acquire an IP address using DHCP.
set dhcp client enable (off|on) [<slot> [<interface>
[<port>]]]
off | on
Keyword to disable (off) or enable (on) the DHCP client for the network port.
set dhcp relay
enable
Allows the IAD to forward DHCP requests from the LAN to a separate
DHCP Server.