Verilink 8100A (34-00237) Product Manual - Manual (Page 83)

C o n f i g u r a t i o n 4-9
Enable/Disable
Conexant Autobaud
Mode
1 Type “4” on the SDSL Configuration menu (Figure 4.10) to enable or
disable Conexant Autobaud mode. The IAD displays the current setting and
prompts you to change it.
2 Type “E” to enable or “D” to disable Autobaud mode. The IAD saves the
configuration and redisplays the SDSL Configuration menu.
Set SDSL Sync Delay
(Lucent)
To set the SDSL Sync Delay (Lucent), follow the steps listed below.
1 Type “5” on the SDSL Configuration menu (Figure 4.10) to enable Sync
Delay, which is paired with Conexant Autobaud mode. The IAD displays
the current Autobaud setting and prompts you to change it.
2 Type “E” to enable or “D” to disable Autobaud mode. If you disable
Autobaud, you must set the SDSL data rate manually. The IAD prompts
you to enter the SDSL Rate.
3 Enter the rate (144 to 2320 kbps, evenly divisible by 8) and press Enter.
4 The IAD saves the configuration and redisplays the SDSL Configuration
menu.
Set SDSL to AccessLan
CPE Mode
Type “6” on the SDSL Configuration menu (Figure 4.10) to set the IAD to
CPE Mode for connecting to an AccessLan DSLAM. The IAD saves the
configuration and redisplays the SDSL Configuration menu.
Set SDSL IMAS
DSLAM (Nortel)
1 Type “7” on the SDSL Configuration menu (Figure 4.10) to set the SDSL
first-try speed for connecting to an IMAS (Nortel) DSLAM. The IAD
displays the IMAS First Speed Option menu (Figure 4.11).
Figure 4.11 IMAS First Speed Option Menu
2 Type the option to select the appropriate SDSL speed.
The IAD saves the configuration and redisplays the SDSL Configuration
menu.
Set SDSL Speed
Manually
1 Type “8” on the SDSL Configuration menu (Figure 4.10) to set the SDSL
speed manually. The IAD prompts you to enter the SDSL Data Rate.
2 Type the rate (144 to 2320 kbps, evenly divisible by 8) and press Enter. The
IAD asks you if you wish to set Data to Framed Mode.