Verilink 8100A (34-00237) Product Manual User Manual
Page 80
Advertising
4-6
8 0 0 0 S e r i e s
NOTICE:
The options displayed on the WAN Configuration menu above are the
options you will see if ATM is the configured Datalink Protocol (refer to
“Configure Datalink Protocol” below).
NOTICE:
You must sign on as Supervisor to configure the WAN interface. Be sure
to reset the IAD when you have finished making changes to WAN
settings. Resetting the IAD causes the configuration changes to take
effect.
Figure 4.4
WAN Configuration Menu (Frame Relay) - Configuring T1/E1
Figure 4.5
WAN Configuration Menu - Configuring ADSL
Figure 4.6
WAN Configuration Menu - Configuring SHDSL
Advertising
This manual is related to the following products: