Verilink 8100A (34-00237) Product Manual - Manual (Page 234)

6-14 8 0 0 0 S e r i e s
set voip
signaling tos
Configures value of the TOS byte of IP header for SIP signaling messages.
set voip signaling tos <0-7>
set voip voice
tos
Configures value of the TOS byte of IP header for RTP voice packets.
set voip voice tos <0-7>
set wan atm ppp
auth
Sets the PPPoATM options—RFC 2364 VC muxing PVCs, as well as LLC
encapsulation PVCs. If authorization is PAP or CHAP, you must specify an
authentication type, UserID and password.
set wan atm ppp auth (none|((PAP|CHAP) <id>
<password>)) [<slot> [<interface> [<port>]]]
none | PAP | CHAP
Keyword to select authorization type.
id
PPP user ID.
password
PPP password.
set wan atm vc Sets an ATM VC on a given WAN port—RFC 1483 and RFC 2364 VC
Muxing PVCs, as well as LLC encapsulation PVCs. You must specify VPI
number, VCI number and RFC encapsulation type. If you do not enter any
optional parameters, it will find the first WAN slot, interface and port.
set wan atm vc <vpi> <vci>
(1483|1483vc|2364|2364vc|voice) [<slot> [<interface>
[<port>]]]
vpi
Virtual Port Identifier (0
− 255)
vci
Virtual Circuit Identifier (32
− 65535—default is 38 for data and 39 for
voice).
1483 | 1483vc | 2364 | 2364vc | voice
Encapsulation type keyword.
set wan bridge Enables and disables bridging on a WAN port.
set wan bridge (off|on) [<slot> [<interface>
[<port>]]]
off | on
Keyword to disable (off) or enable (on) bridging on the specified port.
set wan datalink Sets the datalink protocol to Frame Relay or ATM. If you don’t enter optional
parameters, it finds the first available slot, interface and port.
set wan datalink (framerelay|atm) [<slot>
[<interface> [<port>]]]