Verilink 8100A (34-00237) Product Manual - Manual (Page 154)

4-80 8 0 0 0 S e r i e s
Figure 4.93 Voice Port Configuration Menu
Configure Busy Out Line Settings
Type “B” on the Voice Port Configuration menu to display the Busy Outline
Settings menu (Figure 4.94). Use this menu to select Busy Out State on all lines
or on individual lines.
Figure 4.94 Busy Out Line Settings Menu
Set Start Mode (Loop Start/Ground Start)
To set start mode (for POTS only), type “S” on the Voice Configuration menu
(Figure 4.70) to display the Start Mode Selection menu (Figure 4.95).
Figure 4.95 Start Mode Selection Menu
NOTICE: The loop start and ground start features apply to ATM signaling only.
Each option on this menu is described in detail below.
Set All Ports to Loop
Start
1 Type “1” to select Set All Ports to Loop Start. The IAD sets all ports to
Loop Start and saves the configuration.
2 Press any key to return to the Start Mode Selection menu or press escape to
continue with other voice path configuration.
3 Reset the IAD when you finish voice path configuration.