Verilink 8100A (34-00237) Product Manual - Manual (Page 76)

4-2 8 0 0 0 S e r i e s
3 Set System Defaults to the Custom defaults setting.
4 Reboot the IAD.
The config.st file will be read and used to set up the DHCP client. Once the
DHCP server has responded, the IAD will use its LAN MAC address to
obtain a file named MAC-address.cfg from the TFTP server specified in the
information returned by the DHCP server. This file will be used as the
operating configuration file and the IAD will reboot once in order to use the
file. If the IAD is rebooted once again, it will go through the DHCP process
again and load the operating configuration again from the TFTP server.
WAN Configuration
Basic WAN Setup Tasks
The IAD WAN can be configured for ATM, Frame Relay, or HDLC
protocols, depending on the interface. (Refer to the flowchart in Figure 4.1.)
The T1/E1 and SDSL interfaces support ATM, Frame Relay, and HDLC. The
ADSL and SHDSL interfaces support ATM only. The USI interface supports
Frame Relay and HDLC. To set up the IAD for voice and data operation, you
must first perform these basic tasks listed below:
•
Configure the WAN interface for your IAD (page 4-5)
•
Select ATM or Frame Relay as the datalink protocol (page 4-4)
•
For ATM protocol, configure ATM PVCs (page 4-24) and ATM options
(page 4-30)
•
For Frame Relay protocol, configure Frame Relay DLCIs (page 4-31) and
Frame Relay options (page 4-34)
• Configure the voice path (page 4-61).