Grass Valley EDIUS Neo 3 - Manual (Page 407)

EDIUS NEO — User Reference Guide 405
Trimming Clips
2. Move the cursor to the edit point over the selected trim handle.
The cursor changes to a trimming cursor as shown in Figure 456 .
Figure 456. End Point Trim Cursor
3. Drag the cursor to the left (trim) or right (lengthen) to adjust the clip at
the end point.
Note You can fine tune trimming by 1-frame or 10-frame units by using the trim
buttons in the trim window or the corresponding keyboard shortcuts. See
Trim Mode Operation Buttons
on page 412 for more details.
When selecting an edit point that is at the end of one clip and the beginning
of another, two sets of trim handles appear as illustrated in
Figure 457 .
Click the trim handle to be active for trimming. The active trim handle is
yellow.
Figure 457. Edit Points Between Clips
Note When an Out point on one clip and an In point on the adjoining clip are both
selected, trimming operations affect both clips.
When lengthening clips, the result will be different based on the Over-
write/Insert mode setting. Examples appear below in
Figure 458 and
Figure 459 .