Yaskawa Sigma-5 User Manual: Operation of Digital Operator - Manual (Page 110)

3 Utility Function Mode
3.2.29 One-parameter Tuning (Fn203)
3-76
5
If the servomotor power is OFF, turn ON the
servo ON (/S-ON) signal. The display will
change from “BB” to “RUN.”
If the servomotor power is ON, go to step 6.
6
Press the Key to display the set value.
7
Press the Key again to display FF
LEVEL and FB LEVEL setting screens.
(cont’d)
Step Display after Operation Keys Operation
㧾㨁㧺   ̆㧻㨚㨑㧼㨞㨙㨀㨡㨚̆
ޓ㧿㨑㨠㨠㨕㨚㨓
㨀㨡㨚㨕㨚㨓ޓ㧹㨛㨐㨑㧩㧞
ޓޓޓޓޓޓޓ㨀㨥㨜㨑㧩㧞
㧾㨁㧺   ̆㧻㨚㨑㧼㨞㨙㨀㨡㨚̆
㧼㨚㧝㧜㧜㧩㧜㧜㧠㧜㧜
㧼㨚㧝㧜㧝㧩㧜㧜㧞㧜㧜㧜
㧼㨚㧝㧠㧝㧩㧜㧜㧡㧜㧜
㧾㨁㧺ޓ ̆㧻㨚㨑㧼㨞㨙㨀㨡㨚̆
㧲㧲ޓ㧸㧱㨂㧱㧸㧩㧜㧜㧡㧜㧚㧜
㧲㧮ޓ㧸㧱㨂㧱㧸㧩㧜㧜㧠㧜㧚㧜