Yaskawa Sigma-5 User Manual: Operation of Digital Operator - Manual (Page 134)

4 Parameter Copy Mode
4.2.1 Read-out Parameters from SERVOPACK (SERVO → OP)
4-4
4
Press the Key.
The display changes to the execution dis-
play.
5
Press the Key to start reading
parameters from the SERVOPACK.
Note: Press the
Key not to exe-
cute reading.
The display returns to the parame-
ter block selection display.
6
When the parameters have been read out
from the SERVOPACK, “Completed” is
displayed.
7
When the parameters were read out and
“Completed” is displayed, the display
returns to the parameter block selection
display. At this moment, the SERVO-
PACK model number is displayed for the
selected block (“SGDV-R70” in the dis-
play on the left).
8
Press the Key. The display returns
to the parameter copy mode menu dis-
play.
(cont’d)
Step Display after Operation Keys Operation
0 0 : ∗ ∗ ∗ ∗
S t a r t : [ R E A D ]
R e t u r n : [ M O D E ]
B B
− S E R V O → O P −
0 0 : ∗ ∗ ∗ ∗
R e a d i n g
P a r a m e t e r s . .
B B – S E R V O
→ O P –
< < S E R V O > >
0 0 : ∗ ∗ ∗ ∗
C o m p l e t e d
B B
− S E R V O → O P −
0 0 : S G D V
− R 7 0
0 1 :
∗ ∗ ∗ ∗
0 2 : ∗ ∗ ∗ ∗
0 3 : ∗ ∗ ∗ ∗
B B
− S E R V O → O P −
B B − C O P Y −
1 : S E R V O
→ O P
2 : O P
→ S E R V O
3 : V E R I F Y
4 : L I S T