Yaskawa Sigma-5 User Manual: Operation of Digital Operator - Manual (Page 141)

4
Parameter Copy Mode
4.2 Operations
4-11
(2) Notes on Verify Parameters Function
• If an empty block (“
∗∗∗∗
”) is selected and the verify function is executed, the mes-
sage “No Data” is displayed, and the verification will not be executed. Press
the Key to return to the parameter block selection display.
• Pressing the Key to cancel the operation while verifying parameters. “Can-
celed” is displayed, and the display returns to the parameter block selection dis-
play.
• During verification operation, the executing process is displayed sequentially as
shown below. The verification takes about 10 seconds.
• If parameter matching is executed with a parameter block that differs from the
model of the SERVOPACK, the message “unmatched parameters” will appear and
matching will not be executed.
Operation cancelled
B B – V E R I F Y –
C a n c e l e d
0 0 :
∗ ∗ ∗ ∗
While reading the parameters from
the digital operator
Operation completed
In verification process
0 0 : S G D V – R 7 0
R e a d i n g
P a r a m e t e r s . .
< < O P > >
B B – V E R I F Y –
B B – V E R I F Y –
V e r i f y i n g
P a r a m e t e r s . .
0 0 : S G D V – R 7 0
< < O P – S E R V O > >
B B – V E R I F Y –
0 0 : S G D V – R 7 0
C o m p l e t e d