Yaskawa Sigma-5 User Manual: Operation of Digital Operator - Manual (Page 28)

2
P
arameter/
M
o
nitor
M
odes
2.1 Parameter Mode
2-5
Note: If the Key has not been pressed but the Key has been pressed to select
another mode such as the utility function mode, any changes that have been made to the
parameter will be saved in the SERVOPACK.
7
Press the Key twice to move the
cursor to the third digit of Pn304.
8
Press the Key five times to
change the setting to “1000.”
9
Press the Key to write the set-
tings.
The cursor moves to the parameter
number side.
Step Display after Operation Keys Operation
B B − P R M / M O N −
P n 3 0 4 = 0 0 5 0 0
U n 0 0 2 =
0 0 0 0 0 0
U n 0 0 8 = 0 0 0 0 0 0 0 0 0 0 0
U n 0 0 D = 0 0 0 0 0 0 0 0 0 0 0
B B − P R M / M O N −
P n 3 0 4 = 0 1 0 0 0
U n 0 0 2 =
0 0 0 0 0 0
U n 0 0 8 = 0 0 0 0 0 0 0 0 0 0 0
U n 0 0 D = 0 0 0 0 0 0 0 0 0 0 0
B B − P R M / M O N −
P n 3 0 4 = 0 1 0 0 0
U n 0 0 2 =
0 0 0 0 0 0
U n 0 0 8 = 0 0 0 0 0 0 0 0 0 0 0
U n 0 0 D = 0 0 0 0 0 0 0 0 0 0 0