Yaskawa Sigma-5 User Manual: Operation of Digital Operator - Manual (Page 26)

2
Parameter/Monitor Modes
2.1 Parameter Mode
2-3
∗ When the setting is modified, the parameters whose modified setting is validated only after
setting validation, the warning A.941 “Change of Parameters Requires the Setting Valida-
tion” is displayed. Turn the power OFF then ON to clear the warning and validate the new
setting.
4
Press the Key to move the cur-
sor to the setting side (to the position of
the first digit of Pn000.0).
5
Press the Key once to set “1”
for the first digit of Pn.000.0.
6
Press the Key.
The new setting of Pn000 is written to
the SERVOPACK. The cursor moves to
the parameter number side and the
warning A.941 is displayed.
7 To enable the change in the setting, turn the power OFF and ON again.*
Step Display after Operation Keys Operation
B B
− P R M / M O N −
P n 0 0 0 = n. 0 0 0 0
U n 0 0 2 = 0 0 0 0 0 0
U n 0 0 8 = 0 0 0 0 0 0 0 0 0 0 0
U n 0 0 D = 0 0 0 0 0 0 0 0 0 0 0
B B
− P R M / M O N −
P n 0 0 0 = n. 0 0 0 1
U n 0 0 2 = 0 0 0 0 0 0
U n 0 0 8 = 0 0 0 0 0 0 0 0 0 0 0
U n 0 0 D = 0 0 0 0 0 0 0 0 0 0 0
A . 9 4 1
− P R M / M O N −
P n 0 0 0 = n. 0 0 0 1
U n 0 0 2 = 0 0 0 0 0 0
U n 0 0 8 = 0 0 0 0 0 0 0 0 0 0 0
U n 0 0 D = 0 0 0 0 0 0 0 0 0 0 0