KACO Powador XP100-HV - Manual (Page 41)

Operating Instructions Powador XP100-HV Page 41
F a u l t s a n d W a r n i n g s
6.2 Faults
Code Message Description
01 PV Over Voltage PV voltage exceeds the parameter [DC over voltage Level]
02 PV Over Current PV current exceeds the parameter [DC over current Level]
03 PV Under Voltage Voltage of the DC input is below the minimum running voltage
04 CB10 (PV Contactor) Failure PV side contactor (CB10) failure
05 PV Polarity Failure Polarity (+, -) of PV side is reversed
06 Ground Fault PV side ground fault
10 Inv. Over Voltage Over voltage on the inverter side
11 Inv. Under Voltage Under voltage on the inverter side
12 Inv. Over Frequency Over frequency on the inverter side
13 Inv. Under Frequency Under frequency on the inverter side
14 Inv. Over Current Over current on the inverter side
15 MC21 (Inv. MC) Failure Inverter side contactor (MC21) failure
16 Inv. Phase Order Phase order failure on the inverter side, wrong phase rotation
18 Inductor or TR Over Temp. Inductor or Transformer temperature is above 150°C
20 PEBB 1 IGBT Fault PEBB 1 IGBT failure
21 PEBB 2 IGBT Fault PEBB 2 IGBT failure
22 PEBB 3 IGBT Fault PEBB 3 IGBT failure
24 PEBB Over Temp. Analog The temperature of the heat-sink exceeds 90°C (194°F)
25 PEBB Over Temp. Digital The heat-sink temperature generated by the thermal trip device has
exceeded operational parameters (Thermal Switch)
30 Grid Over Voltage Level 1 Over voltage Level 1 on the grid side
31 Grid Under Voltage Level 1 Under voltage Level 1 on the grid side
32 Grid Over Frequency Level 1 Over frequency Level 1 on the grid side
33 Grid Under Frequency
Level 1 Under frequency Level 1 on the grid side
34 CB20 (Grid SW) Trip CB20 (AC Disconnect/Grid circuit breaker) was tripped during operation
35 Grid Over Voltage Level 2 Over voltage Level 2 on the grid side
36 Grid Under Voltage Level 2 Under voltage Level 2 on the grid side
37 Grid Under Frequency
Level 2 Under frequency Level 2 on the grid side
38 Grid Over Frequency Level 2 Over frequency Level2 on the grid side
40 Parameters Version Error Diff erent version between the NVSRAM parameter table and the pro-
gram parameter table
41 Flash Memory Failure C6000 DSP program fl ash memory failure in XCU (main control) board