Emerson E2 - Manual (Page 203)

Toggling Full Options Operator’s Guide to Using the E2 • 12 - 3
12.3 Toggling Full Options
Toggling Full Options on allows you to have full
access to programming applications. To Toggle Full
Options on:
1. Press the

key
2. Select

(System Configuration)
3. Select

(System Information)
4. Select

(Toggle Full Options)
FULL will appear in the top right corner of the screen
when Full Options is enabled. Pressing

toggles Full
Options on and off.
12.4 Navigation
12.4.1 Menus
Main Menu
The Main Menu is accessed by pressing the

key. This menu gives you direct access to applications
such as Suction Groups, Condensers, Circuits, Air Han-
dling Units, Zones, Light Schedules, and Sensor Controls
applications, (depending on which controller type you are
using) as well as all configured applications in the control-
ler. The Main Menu also allows you to add and delete
applications, gives system configuration abilities, and
shows status information for inputs and outputs, network,
graphs and logs.
The System Configuration Menu
The System Configuration Menu is one of the menus
used to set up the E2. Included options are Input/Output
Definitions, internal system information, remote commu-
nications, global data, alarm, logging, and network setup
information.
To open the System Configuration menu:
1. Press

2. Press

(System Configuration)
The System Configuration menu contains nine menu
items:
Figure 12-4 - Main Menu
Figure 12-5 - System Configuration Menu
Menu Option Description
1 - Input Definitions View the status of all input
boards, as well as set up individ-
ual points on the I/O boards.
2 - Output Definitions View the status of all output
boards, as well as set up individ-
ual points on the I/O boards.
3 - System Information Menu that gives access to more
E2 setup options and informa-
tion.
4 - Remote Communica-
tions Gives access to modem informa-
tion, dial-out setup, and TCP/IP.
Table 12-2 - System Configuration Menu Options