Emerson E2 User Manual
Page 235
Appendix C: Alarm Advisory Messages
•
C
-
13
RX/BX Firmware Update Failed
20
The E2’s firmware update was not successful.
RX/BX Firmware Was Updated
50
The E2’s firmware was successfully updated.
Smoke Detected
30
A smoke detector input on an ARTC/MultiFlex RTU
has detected smoke.
SRAM Memory Corrupted -
Reboot
30
A problem with memory has resulted in a reset of the
E2.
State Switched 'On'
User
A digital value that has been set up to alarm when
ON has switched ON.
Status Config Loss-CRC Error
30
An internal error has occurred in the E2.
Stuck
30
MultiFlex ESR controller has detected a stuck valve.
System date needs manual reset
20
The date/time of the box is not valid.
System In Pump Down
User
The suction pressure has fallen below the pump down
setpoint for a Suction Group, causing shutdown of
the rack.
Template File Bad - CC100 Liq
15
A template file in E2 for a CC-100P or CC-100LS is
bad.
Template File Bad - CC100 Suct
15
A template file in E2 for a CC-100H is bad.
Template File Bad - CS100 Ckt
15
A template file in E2 for a CS-100 is bad.
Test Dial Successful
50
E2 performed a test dial-out with its modem, and the
dial-out was successful.
Time Updated By A User
99
A user changed the time in the current E2.
Time Updated Over Network
99
The time in the current E2 was updated by another
controller or user on the network.
Timed Out Waiting For FW Updt.
50
The E2 waited for a firmware update to begin, and it
never did.
Too Many Reboots: Flash erased
50
A number of successive reboots has erased the Flash
RAM.
Too Many Reboots: SRAM erased 50
A number of successive reboots has erased the
SRAM.
Total On Time Exceeded Limit
User
A digital value’s total ON time has exceeded its
defined Time ON Total setpoint.
Trip Alarm
30
Generic pulse trip alarm.
Tripped
20
WPK condenser fan or compressor trip.
Unit Ctlr Cell Create Failed
20
The E2 unsuccessfully tried to create a unit controller
cell.
Unknown FW Update Attempted
50
An error has occurred during a firmware update of
E2. Call Retail Solutions service for assistance.
Unknown Heap Operation Error
50
There is an internal error in the E2 software. Notify
Retail Solutions service.
Unoccupied Hi Limit Exceeded
User
An analog value has risen above its defined high limit
setpoint during UNOCCUPIED mode.
Unoccupied Low Limit Exceeded
User
An analog value has fallen below its defined low
limit setpoint during UNOCCUPIED mode.
Alarm Name
Default
Priority
Definition