Emerson E2 - Manual (Page 51)

Setting up the E2 E2 Hardware Setup • 4 - 1
4 E2 Hardware Setup
4.1 Setting up the E2
4.1.1 Enclosure
Open the door and expose the main processor board.
The main processor board and power interface board (PIB)
are mounted side by side, one on each side of the box
enclosure.
4.1.2 Main Processor Board
The main processor board is mounted on the hinged
door part of the enclosure, directly behind the keyboard.
Figure 4-1 - E2 Inside Enclosure
Figure 4-2 - E2 Main Board (RX-100 Board Shown)
12
13
14
Boot Status LED
12
13
General Status LED
14
Backlight Dim Adjust (E2 100 Ver. Only)
Contrast Adjust (E2 100 Ver. Only)
Backlight Inverter
LCD Connector
Echelon Plug-In
Power Interface Board Connector
TCP/IP Ethernet Connector
External Keyboard Connector
Lithium Battery
Battery Enable Switch
Reset and Clean Out Buttons
Test Button
10
9
11
8
4
5
6
2
3
7
1