PLANET VIP-191 - Manual (Page 119)

To create a new profile for your AP, carry out the following steps:
1. Open AP Connection Æ Add New.
2. For AP that only uses 802.1x authentication, set the profile like the following diagram:
Figure 207. AP profile setting
3. For AP that uses both WPA and 802.1x authentication, set the EAP type to TLS, just as shown
below:
Figure 208. EAP type - TLS
4. If you want to validate your server to check for information on the server to make sure you are
connecting to the right server, check the “Validate Server” checkbox, as shown below:
Figure 209. Enable the validate server
5. When you press the Right (“Connect”) Key on the Wireless Properties to try to connect to the
AP, a dialog box should pop up to prompt you for your login information (login id, password, and
domain name).
6. If the authentication process is successful, you will be able to obtain an IP address.
119