FUJITSU Semiconductor Controller MB89950/950A - Manual (Page 224)

210
CHAPTER 10 UART
Table 10.4-3 Serial status and data register (SSD) bits
Bit Function
Bit 7 RDRF:
Receive data register
full bit • This flag represents the status of the serial input data register (SIDR).
• This flag is set when receiving data is loaded into the SIDR register. It is cleared
when the SIDR register is read. If the RDRF bit is set when the RIE bit is "1", a
receive interrupt request is generated.
Bit 6 ORFE:
Overrun/Framing
error flag bit • This bit is set when overrun or framing error is generated during receiving.
• If this flag is set, data is not transferred from the receive shift register to SIDR
register.
• When the SIDR register is read after reading the SSD register with the ORFE flag set
to "1", the ORFE flag is cleared to "0".
• If the ORFE bit is set when the RIE bit is "1", a receive interrupt request is
generated.
Bit 5 TDRE:
Transmission data
register empty bit • This flag represents the status of the serial output data register (SODR).
• This flag is cleared when transmission data is written into the SODR register. It is set
when the data is loaded into the transmit shifter and transmission begins. If the
TDRE bit is set when the TIE bit is "1", a transmission interrupt request is generated
Bit 4 TIE:
Transmitter interrupt
enable bit • This bit enables transmission interrupt. If the TDRE bit is "1", a transmission
interrupt is immediately generated once transmission interrupt enable bit is set to
"1".
Bit 3 RIE:
Receiver interrupt
enable bit • This bit enables receive interrupt. If the RDRF bit is "1" or if any error flag is "1", a
receive interrupt is immediately generated once receive interrupt enable bit is set to
"1".
Bit 2 Unused bit • The read value is indeterminate.
• Writing to this bit has no effect on the operation.
Bit 1
TD8/TP:
Transmitted data
parity selection bit • This bit is used to select the parity for the transmitted data.
Bit 0 RD8/RP:
Received data parity
selection bit • This bit is used to select the parity for the received data.