Siemens MC35 - Manual (Page 105)

AT Command Set
MC35_ATC_01_V03.02 Page 105 of 228 13.03.2002
Example 3 To change the "PS" lock password, using the correct old password:
AT+CPWD=PS,1111,2222
(where 1111 = old "PS" password and 2222 =
new password)
To specify a new "PS" lock password, after the old password was disabled, e.g.
after three failed attempts to enter the password (only if Master Phone Code is
availbale):
AT+CPWD=PS,12345678,1111
(where 12345678 is the Master Phone code
and 1111 is the new password. You may also
use <newpwd> to restore the former disabled
password). This operation deactivates the
present phone lock and sets a new one. See
also Chapter 4.31.1.
Alternatively, whithout giving a new password:
AT+CPWD=PS,12345678
Deactivates the present phone lock.
4.35 AT+CR Service reporting control
Test command
AT+CR=?
Response
+CR: (list of supported <mode>s) OK
Parameter
See write command
Read command
AT+CR?
Response
+CR: <mode> OK
Parameter
See write command
Write command
AT+CR=<mode>
Response
Configures the TA whether or not to transmit an intermediate result code +CR:
<serv> to TE when a call is being set up.
OK
Parameter
<mode> 0 disable
1 enable
Intermediate result code
If enabled, an intermediate result code is transmitted at the point during con-
nect negotiation when the TA has determined the speed and quality of service
to be used, before any error control or data compression reports are transmit-
ted, and before any final result code (e.g. CONNECT) appears.
+CR:<serv
>
Parameter
<serv> REL ASYNC asynchronous non-transparent
Reference
GSM 07.07
Note
The PLMN influences the second air interface (to the terminator), therefore an-
other mode may be established from the network