Siemens MC35 - Manual (Page 147)

AT Command Set
MC35_ATC_01_V03.02 Page 147 of 228 13.03.2002
6.1.5 AT+CGQMIN Quality of Service Profile (Minimum acceptable)
Test command
AT+CGQMIN=?
The test command returns values supported as a compound value. If the
MT supports several PDP types, the parameter value ranges for each PDP
type are returned on a separate line.
Response
+CGQMIN: <PDP_type>, (list of supported <precedence>s), (list of sup-
ported <delay>s), (list of supported <reliability>s) , (list of supported
<peak>s), (list of supported <mean>s) [<CR><LF>+CGQMIN: ...]
OK/ERROR/+CME ERROR
Parameter
<PDP_type> String parameter of Packet Data Protocol type
IP
<precedence> See write command
<delay> See write command
<reliability> See write command
<peak> See write command
<mean> See write command
Read command
AT+CGQMIN?
Response
The read command returns the current settings for each defined context. If
no minimum profile was explicitly specified for a context, simply OK will be
returned, but default values will be used for that context.
+CGQMIN: <cid>, <precedence>, <delay>, <reliability>, <peak>, <mean>
[<CR><LF>+CGQMIN: ...]
OK/ERROR/+CME ERROR
Parameter
<cid> See write command
<precedence> See write command
<delay> See write command
<reliability> See write command
<peak> See write command
<mean> See write command
Write command
AT+CGQMIN=
[<cid>[,<precedence>
[,<delay>[,<reliability>
[,<peak>[,<mean>]]]]]]
This command allows the TE to specify a minimum acceptable profile
which is checked by the MT against the negotiated profile returned in the
Activate PDP Context Accept message.
The set command specifies a profile for the context identified by the (local)
context identification parameter, <cid>.
A special form of the set command, +CGQMIN= <cid> causes the mini-
mum acceptable profile for context number <cid> to become undefined. In
this case no check is made against the negotiated profile.
AT&F and ATZ will undefine the minimum QoS profiles of every context
which is not active or not online.