At+fcig query or set the local polling id, At+fclass fax: select, read or test service class, 4 at+fcig query or set the local polling id – Siemens MC35 User Manual
Page 42
AT Command Set
MC35_ATC_01_V03.02
Page 42 of 228
13.03.2002
3.4 AT+FCIG Query or set the Local polling id
Test command
AT+FCIG =?
Response
(max. length of Local Polling ID string) (range of supported ASCII character val-
ues) OK
Parameter
See write command
Read command
AT+FCIG?
Response
<id> OK
Parameter
See write command
Write command
AT+FCIG =<id>
Response
OK
Parameter
<id>
Local Polling ID string, max. length and possible content as reported
by test command. Default value is empty string (“”).
Reference
EIA PN-2388
Note
See also “AT+FLID Query or set the Local Id setting capabilities”, pg. 48.
Used for Faxclass 2 only
3.5 AT+FCLASS Fax: Select, read or test service class
Test command
AT+FCLASS=?
See introduction to fax commands, pg. 40.
Response
(list of supported <n>s)
OK
Parameter
See write command
Read command
AT+FCLASS?
Response
<n> OK
Parameter
See write command
Write command
AT+FCLASS=
<n>
The ME is set to a particular mode of operation (data, fax). This causes the MA
to process information in a manner suitable for that type of information.
Response
OK
Parameter
<n>
0
data (e.g. EIA/TIA-602 or ITU V.25ter)
1
Fax class 1 (EIA/TIA-578-A, Service Class 1)
2
Fax class 2 (EIA/TIA SP-2388, an early draft version of
EIA/TIA-592-A – Service class 2.1)
Reference
EIA/TIA-592-A
Note
Using Error Correcting Mode (ECM) when sending FAXes over GSM should be
avoided.