Siemens MC35 - Manual (Page 214)

AT Command Set
MC35_ATC_01_V03.02 Page 214 of 228 13.03.2002
Number Description
Service or option not available class
49
Quality of service unavailable
50 Requested facility not subscribed
55 Incoming calls barred within the CUG
57 Bearer capability not authorized
58 Bearer capability presently not available
63 Service or option not available, unspecified
Service or option not implemented
65
Bearer service not implemented
68 ACM equal or greater than ACMmax
69 Requested facility not implemented
70 Only restricted digital information bearer capability is available
79 service or option not implemented, unspecified
Invalid message (e.g. parameter out of range) class
81
Invalid transaction identifier value
87 User not member of CUG
88 Incompatible destination
91 Invalid transit network selection
95 Semantically incorrect message
Protocol error (e.g. unknown message) class
96
Invalid mandantory information
97 Message type non-existant or not implemented
98 Message type not comaptible with protocol state
99 Information element non-existent or not implemented
100 Conditional information element error
101 Message not compatible with protocol
102 Recovery on timer expiry
111 Protocol error, unspecified
Interworking class
127
Interworking, unspecified
9.1.12 SIEMENS release cause for L3 Call Control (CC) (AT+CEER)
Number Description
1 Call dropped
2 Service not available
3 Hold procedure not available
4 Temporary no service, previous procedure not yet finished
5 No speech service available
6 Call reestablishment procedure active
7 Mobile received a release (complete) message during a modify procedure (modify re-
ject)
8 Call clearing, because loss of radio connection, if no reestablishment is allowed (call
not active)
10 Number not included in FDN list
Notifications
300
Called party barred incoming call