Siemens MC35 - Manual (Page 83)

AT Command Set
MC35_ATC_01_V03.02 Page 83 of 228 13.03.2002
4.22 AT+CMEE Report mobile equipment error
Test command
AT+CMEE=?
Response
+CMEE: (list of supported <n>s ) OK
Parameter
See write command
Read command
AT+CMEE?
Response
+CMEE: <n> OK
Parameter
See write command
Write command
AT+CMEE=<n>
This command controls the presentation of the result codes +CME ER-
ROR: <err> and CMS:<err> that indicate errors relating to ME functional-
ity.
When you power down or reset the ME with AT+CFUN=1,1 the setting will
be reset to its default. The levels 1 or 2 need to be selected every time
you reboot the ME, or may be included, for permanent use, in the user
profile saved with AT&W.
Response
OK
Parameter
<n> 0 disable result code (only 'ERROR' will be displayed)
1 enable result code and use numeric values
2 enable result code and use verbose values
Example To obtain enhanced error messages it is recommended to choose <n>=2.
AT+CMEE=2
OK
Reference
GSM 07.07
Note
• The possible error result codes are listed in chapter 9
• In multiplex mode (see “AT+CMUX Enter multiplex mode”, pg. 85) the
setting applies only to the logical channel where selected. The setting
on the other channels may differ.