Siemens MC35 - Manual (Page 48)

AT Command Set
MC35_ATC_01_V03.02 Page 48 of 228 13.03.2002
3.13 AT+FET End a page or document
Write command
AT+FET=<ppm>
This command indicates that the current page or partial page is complete. An
ERROR response code results if this command is issued while the mode is on-
hook.
Response
OK
Parameter
<ppm> Post Page Message Codes
1 another document next
2 no more pages or documents
4 another page, procedure interrupt
5 another document, procedure interrupt
Reference
EIA PN-2388
Note
Used for Faxclass 2 only
3.14 AT+FK Kill operation, orderly FAX abort
Execute command
AT+FK
This command causes the TA to terminate the session in an orderly manner.
Response
OK
Reference Note
Used for Faxclass 2 only
3.15 AT+FLID Query or set the Local Id setting capabilities
Test command
AT+FLID =?
Response
(max. character length of Local ID string) (range of supported ASCII character
values) OK
Parameter
See write command
Read command
AT+FLID?
Response
< lid > OK
Parameter
See write command
Write command
AT+FLID =<lid>
Response
OK
Parameter
<lid> Local ID string, max. length and possible content as reported by test
command. Default value is empty string (“”).
Reference
EIA PN-2388
Note
See also “AT+FCIG Query or set the Local polling id”, pg. 41.
Used for Faxclass 2 only