Siemens MC35 - Manual (Page 94)

AT Command Set
MC35_ATC_01_V03.02 Page 94 of 228 13.03.2002
4.30 AT+CPBW Write phonebook entry
Test command
AT+CPBW=?
Response
TA returns location range supported by the current storage, the maximum
length of <number> field, supported number formats of the storage and the
maximum length of <text> field.
Note: The length may not be available while SIM storage is selected. If storage
does not offer format information, the format list should be empty parenthe-
sises.
+CPBW: (list of supported <index>s), <nlength>, (list of supported <type>s),
<tlength> OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameter
See write command.
Write command
AT+CPBW=
[<index>]
[,<number>
[[,<type>]
[,<text>]]]
This command writes a phonebook entry to the memory location <index> of the
active memory.
The memory location number <index> is followed by the phone number <num-
ber> (in the format <type>) and the associated <text>.
If writing fails, an ME error +CME ERROR: <err> is returned.
Parameter
<index> Location number within phonebook memory, total range is given
in test command response
<number> Phone number, maximum length is given as <nlength> in test
command response
<type> Type of phone number (address octet in integer format); 145 when
dialling string includes international access code character “+”,
otherwise 129 (refer GSM 04.08 subclause 10.5.4.7)
<text> Text assigned to the phone number, maximum length is given in
test command response <tlength>. Character set as specified with
+CSCS. See note below.
<nlength> Max. length of phone number, normally 20, for a small number of
locations 40
<tlength> Max. length of text assigned to phone number (depending on
storage type 16 - 18 characters including blanks)
Response
OK/ERROR/+CME ERROR
To delete a phonebook entry simply enter the location number:
AT+CPBW=<index>
To write a phonebook entry to the first free location number:
AT+CPBW=,<number>,<type>,<text>
Reference
GSM 07.07
Note
If <text> contains characters which are coded differently in ASCII and GSM
(e.g. Д, Ц, Ь), these characters have to be entered via escape sequences as
described in chapter “Supported character sets“, pg. 11.