Siemens MC35 - Manual (Page 53)

AT Command Set
MC35_ATC_01_V03.02 Page 53 of 228 13.03.2002
3.27 AT+FVRFC Vertical resolution format conversion
Test command
AT+FVRFC =?
This command determines the DCE response to a mismatch between the vertical
resolution negotiated for the facsimile session and the Phase C data desired by
the DTE.
Response
(List of supported mismatch checking modes) OK
Parameter
See write command
Read command
AT+FVRFC?
Response
<vrfc> OK
Parameter
See write command
Write command
AT+FVRFC
=<vrfc>
Response
OK
Parameter
<vrfc> 0 disable mismatch checking.
2 enable mismatch checking, with resolution conversion of 1-D
data in the DCE, and an implied AT+FK command executed
on 2-D mismatch detection
Reference
EIA PN-2388
Note
Used for Fax class 2 only
The following AT commands are dummy commands. Invoking these commands will not cause ER-
ROR result codes, but these commands have no functionality.
AT+FAA Auto Answer mode
AT+FECM Error Correction Mode control
AT+FLNFC Page Length format conversion
AT+FLPL Indicate document available for polling
AT+FMINSP Minimum Phase C speed
AT+FRBC Phase C data receive byte count
AT+FREL Phase C received EOL alignment
AT+FSPL Enable polling
AT+FTBC Phase C data transmit byte count
AT+FWDFC Page width format conversion