Siemens MC35 - Manual (Page 153)

AT Command Set
MC35_ATC_01_V03.02 Page 153 of 228 13.03.2002
<peak> numeric parameter for the peak throughput class
0 network subscribed value
Peak Throughput Class Peak Throughput
(in octets per second)
1 Up to 1 000 (8 kbit/s).
2 Up to 2 000 (16 kbit/s).
3 Up to 4 000 (32 kbit/s).
4 Up to 8 000 (64 kbit/s).
5 Up to 16 000 (128 kbit/s).
6 Up to 32 000 (256 kbit/s).
7 Up to 64 000 (512 kbit/s).
8 Up to 128 000 (1 024 kbit/s).
9 Up to 256 000 (2 048 kbit/s).
<mean> numeric parameter for the mean throughput class
0 network subscribed value
Mean Throughput Class
Mean Throughput
(in octets per hour)
1 100 (~0.22 bit/s)
2 200 (~0.44 bit/s)
3 500 (~1.11 bit/s)
4 1 000 (~2.2 bit/s)
5 2 000 (~4.4 bit/s)
6 5 000 (~11.1 bit/s)
7 10 000 (~22 bit/s)
8 20 000 (~44 bit/s)
9 50 000 (~111 bit/s)
10 100 000 (~0.22 kbit/s)
11 200 000 (~0.44 kbit/s)
12 500 000 (~1.11 kbit/s)
13 1 000 000 (~2.2 kbit/s)
14 2 000 000 (~4.4 kbit/s)
15 5 000 000 (~11.1 kbit/s)
16 10 000 000 (~22 kbit/s)
17 20 000 000 (~44 kbit/s)
18 50 000 000 (~111 kbit/s)
31 best effort.
Note: If parameters are not defined, the parameter default values depend on
the HLR-stored subscribed default values.
If some of the QoS parameters are omitted, then they will keep their current
value (or the default value if not specified so far), e.g.
at+cgqreq?
OK
at+cgqreq=1,0
OK
at+cgqreq?
+CGQREQ:1,0,0,0,0,0
OK