Siemens MC35 - Manual (Page 27)

AT Command Set
MC35_ATC_01_V03.02 Page 27 of 228 13.03.2002
2.24 ATS6 Set pause before blind dialling
Read command
ATS6?
Response
<n> OK
Write command
ATS6=<n>
No effect for GSM
Response
OK
Parameter
<n> 000-255 number of seconds to wait before blind dialling.
Reference
V.25ter
Note
2.25 ATS7 Set number of seconds to wait for connection completion
Read command
ATS7?
Response
<n> OK
Write command
ATS7=<n>
Specifies the number of seconds the TA will wait for the completion of the call
setup when answering or originating a data call. Also referred to as "no answer
timeout". To put it plainly, this is the time to wait for the carrier signal. If no carrier
signal is received within the specified time, the TA hangs up.
Response
OK
Parameter
<n>0 <n> 000 – 060 no. of seconds to wait for connection completion.
Reference
V.25ter
Note
• Values greater than 60 cause no error, but <n> will be restored to the maxi-
mum value of 60.
• If called party has specified a high value for ATS0=<n>, call setup may fail.
• The correlation between ATS7 and ATS0 is important.
Example: Call setup may fail if ATS7=30 and ATS0=20.
• ATS7 is only applicable to data calls.
2.26 ATS8 Set number of seconds to wait for comma dial modifier
Read command
ATS8?
Response
<n> OK
Write command
ATS8=<n>
No effect for GSM
Response
OK
Reference
V.25ter
Note