Siemens MC35 - Manual (Page 191)

AT Command Set
MC35_ATC_01_V03.02 Page 191 of 228 13.03.2002
8.25 AT^SNFV Set loudspeaker volume
Test command
AT^SNFV=?
Response
^SNFV: (list of supported <outStep>s) OK
Parameter
See write command
Read command
AT^SNFV?
Response
^SNFV: <outStep>
OK
Parameter
See write command
Write command
AT^SNFV=<out
Step>
Response
TA sets the volume of the loudspeaker to the value <outCalibrate> addressed by
<outStep>.
OK
Parameter
<outStep> Volume range 0 to 4
Reference
Siemens
Note
• Read and write commands are related to the active audio mode.
• The changes are allowed in audio modes 2 to 6.
• <outStep> can be changed by AT^SNFO, too.
• <outCalibrate> can be changed by AT^SNFO.
• AT^SNFW does not save the changed <outStep> value. The setting will be
saved when you switch off the module with AT^SMSO.
8.26 AT^SNFW Write audio setting in non-volatile store
Test command
AT^SNFW=?
Response
OK
Execute command
AT^SNFW
Response
TA writes the active audio parameters in non-volatile store related to the active
mode.
OK
If error is related to ME functionality:
+ CME ERROR: <error>
<error> memory failure Flash write error
Reference
Siemens
Note
• Execute command works only in audio mode 2 to 6.
• TA writes the following audio parameter values in non-volatile store:
<inBbcGain>, <inCalibrate>, <outBbcGain>, <outCalibrate[0]> ... <outCali-
brate[4]>, <side Tone>