PIONEERPOS AT Commands G24-LC - Manual (Page 115)

Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-51
The following table shows the +CSSN parameters.
Table 3-26: +CSSN Parameters
<Parameter> Description
<n> Sets/displays the +CSSI result code presentation status. This value must be specified.
0
Disable (default)
1 Enable
<m> Sets/displays the +CSSU result code presentation status. This value is optional, but
cannot be specified without <n>.
0
Disable (default)
1 Enable
Table 3-27: +CSSI Notification Values
Value Description G24-L Support
0 Unconditional call forwarding is
active Yes
1 Some conditional call forwarding
is active Yes
2 Call has been forwarded Yes
3 Call is waiting Yes (GSM only)
4 CUG call (<index> is present) Yes
5 Outgoing calls are barred Yes
6 Incoming calls are barred Yes
7 CLIR suppression rejected Yes
8 Call has been deflected No
Table 3-28: +CSSU Notification Values
Value Description G24-L Support
0 This is a forwarded call
(mobile-terminated call setup). Yes
1 CUG call (<index> is present;
mobile-terminated call setup). Yes
2 Call has been put on hold (during
a voice call) Yes
3 Call has been retrieved (during a
voice call) Yes
4 Multiparty call has been entered
(during a voice call) Yes